Imprint

The website is a private project of the participants of the University of Applied Sciences Würzburg-Schweinfurt   and is composed of many different sources. Prof. Dr.-Ing. Volker Bräutigam of the Faculty of Industrial Engineering and Management of the FHWS is responsible for the content of this website in his function as chair holder for technical management / digitalisation.

The project spin-off FHWSvsVirus is a spontaneous, non-profit, not-for-profit project, which was created out of necessity in response to the geopolitical situation caused by the worldwide COVID-19 (Coronavirus SARS-CoV-2) pandemic. As the highest premise, commercial and private economic goals are excluded. In contrast, the project is to be financed by public funds, crowd foundations and voluntary donations in an unbureaucratic manner. Should this unknowingly violate copyrights, trademark rights (registered designs) or patents, we apologize and ask for an examination from a charitable and humanitarian point of view. The aim is the collective research and development of an open source/low budget ventilator and its subcomponents for free distribution, further processing and use in the medical environment and exclusion of any claims for damages and warranty.

Information according to § 5 TMG

Volker Prof. Dr.-Ing. Bräutigam
Manfred-Kniess Strasse 3c
97526 Sennfeld

Kontakt

Phone: +4917631693245
E-Mail: volker.braeutigam@fhws.de

Liability for contents

As a service provider, we are responsible for our own content on these pages according to § 7 para.1 TMG (German Telemedia Act) and general laws. According to §§ 8 to 10 TMG, we are not obliged to monitor transmitted or stored external information or to investigate circumstances that indicate illegal activity.

Obligations to remove or block the use of information according to general laws remain unaffected. However, liability in this respect is only possible from the time of knowledge of a concrete infringement. If we become aware of any such infringements, we will remove such content immediately.

Liability for links

Our offer contains links to external websites of third parties, on whose contents we have no influence. Therefore we cannot assume any liability for these external contents. The respective provider or operator of the sites is always responsible for the contents of the linked sites. The linked pages were checked for possible legal violations at the time of linking. Illegal contents were not identifiable at the time of linking.

However, a permanent control of the contents of the linked pages is not reasonable without concrete evidence of a violation of the law. If we become aware of any infringements, we will remove such links immediately.

Copyright

The contents and works on these pages created by the site operators are subject to German copyright law. The reproduction, editing, distribution and any kind of use outside the limits of copyright law require the written consent of the respective author or creator. Downloads and copies of these pages are only permitted for private, non-commercial use.

Insofar as the content on this site was not created by the operator, the copyrights of third parties are respected. In particular, third-party content is marked as such. Should you nevertheless become aware of a copyright infringement, please inform us accordingly. If we become aware of any infringements, we will remove such contents immediately.

Source: https://www.e-recht24.de

 

Disclaimer

All devices on this page are not certified medical devices. According to current regulations, it is not permitted to use them on humans. Neither the individual contributors and sponsors nor any other person associated with the project can accept any responsibility whatsoever for the results or consequences of any experiment using or adopting the information presented on this site.

NOTE: This is a research project It is not recommended at this point to print parts and use 3D printing resources for other things. The project is ongoing and subject to rapid change!